32x320 1/8" BSP Double Actuator Cylinder - 60M2L032A0320 Compliance with ISO 15552 standards and with the previous DIN/ISO 6431 - VDMA 24562 standards Rolled stainless steel rod Clean design with adjustable pneumatic cushioning Special designs available Type of construction: with tie-rods (inside the profile) Operation: double-acting, single-acting, tandem. Low friction version: double-acting only Materials: standard = AL end-blocks and piston, rolled stainless steel AISI 420B rod, anodized AL tube, zinc-plated steel tie-rods and tie-rod nuts, PU seals; low friction = standard materials with NBR piston seal and NBR rod seal (FKM rod seal on request) Type of mounting: with front rear flange, foot mounting, with front/rear/centre/swivel trunnion Strokes min - max: 10 to 2500 mm Operating temperature: 0°C to 80°C (with dry air - 20°C) Operating pressure: 1 to 10 bar (standard versions) - 0,1 to 10 bar (low friction version) Speed: 10 to 1000 mm/sec, no load (standard versions) 5 to 1000 mm/sec, no load (low friction version) Fluid: filtered air, without lubrication. For standard versions only: if lubricated air is used, it is recommended to use oil ISOVG32. Once applied the lubrication should never be interrupted. Full range of ISO cylinders available including large bore (160, 200 & 250mm) and stainless steel options.